.Annex60.Utilities.Math.IntegratorWithReset

Information

This model is similar to Modelica.Blocks.Continuous.Integrator except that it optionally allows to reset the output y of the integrator.

The output of the integrator can be reset as follows:

• If reset = Annex60.Types.Reset.Disabled, which is the default, then the integrator is never reset.
• If reset = Annex60.Types.Reset.Parameter, then a boolean input signal trigger is enabled. Whenever the value of this input changes from false to true, the integrator is reset by setting y to the value of the parameter y_reset.
• If reset = Annex60.Types.Reset.Input, then a boolean input signal trigger is enabled. Whenever the value of this input changes from false to true, the integrator is reset by setting y to the value of the input signal y_reset_in.

See Annex60.Utilities.Math.Examples.IntegratorWithReset for an example.

Implementation

To adjust the icon layer, the code of Modelica.Blocks.Continuous.Integrator has been copied into this model rather than extended.

Revisions

• November 1, 2016, by Michael Wetter:
  Corrected wrong annotation for y_reset, and made rendering of y_reset_in conditional.
  This is for #562.
• September 29, 2016, by Michael Wetter:
  Refactored model to use a type for configuration of the integrator reset.
• August 9, 2016, by Michael Wetter:
  Reformulated model using a conditional connector to use the same design pattern as is used in other models.
• August 9, 2016, by Michael Wetter:
  Revised model.
• July 18, 2016, by Philipp Mehrfeld:
  First implementation.